Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jwiderberg

Pages: [1]
1
Questions / COnnecting an analog servo to Makey Makey
« on: April 15, 2015, 08:33:24 PM »
Hi there,

I'm trying to work out if I can hook up an analog servo (http://www.seeedstudio.com/depot/Grove-Servo-p-1241.html) to the Makey Makey. As far as I can work out, I get an initial "ping" from the servo once the GND and 5V pins are connected. But in terms of SIG, I've tried D14, D16 and D15 and there is no further servo movement - I would've hoped that the output triggered by the MM would trigger the servo. Bit of an Arduino newbie. I've attached a photo that hopefully gives more detail as to the configuration.

Thanks!

Jakob



Pages: [1]